Product Description

Prime Flex 910 is a hydrophobic single-component polyurethane resin with a super low viscosity (35-50 cps) that reacts with moisture when injected into soil forming a rock hard, water-tight mass. 910 is used to stabilize loose soil or sand (permeation grouting), stop underground water flows and seal leaking seawalls. It requires the use of Prime Kat or Kick Fast catalyst.

Recommended Uses

  • Stabilizing loose sand and soil
  • Permeation grouting
  • Compaction grouting
  • Tie back anchors

Typical Areas of Use

  • Seawalls
  • Highways, roads and bridges
  • Airport runways and taxiways
  • Earthen dams
  • Excavation pits and tunneling launch pits
  • Retaining walls
  • Sink holes


  • Encapsulates and strengthens loose soil
  • Super low viscosity for good penetration
  • Watertight
  • Controllable set time
  • Pumped as a single component
  • Meets Florida DOT specifications for chemical grout injection of soil

Completed Projects

• Inter-County Connector – Montgomery/Prince Georges County, MD
• Naval Academy – Annapolis, MD
• Ohio Department of Transportation – Columbus, OH

Cured Characteristics

When cured, Prime Flex 910 exhibits a tensile strength (ASTM D3574) of 23 p.s.i., tensile elongation (ASTM D3574) of 3%, zero shrinkage and a compressive strength (with fine sand) (ASTM D695) of 745 p.s.i.


Prime Flex 910                 45 lb. pails, 50 gallon drums, 300 gallon totes


Made in the U.S.A.


Recommended Products:

View Prime Flex 920 Details

Prime Flex 920

Stop gushing leaks. Stabilize loose soils. Low viscosity, hydrophobic, water-activated polyurethane resin is also verified to meet NSF/ANSI Standard 61 for contact with potable water. Great for seawalls and municipal water utility use.

View Details »
View Titan Airless Pumps - Modified Details

Titan Airless Pumps - Modified

General Description Impact: These small, lightweight electric pumps can deliver any of the Prime Flex products as a single-component material. Use in any combination with[…]

View Details »
View Prime Kat Details

Prime Kat

Our proprietary catalyst for use with Prime Resins hydrophobic polyurethane injection resins. Use in concentrations of 1/2% to 10% to vary set times.

View Details »
View Kick Fast Details

Kick Fast

Our proprietary catalyst for use with hydrophobic polyurethane injection resins when very fast set times are required, such as when dealing with extremely cold water.

View Details »
Translate »