Prime Resins, Inc.
2291 Plunkett Road
Conyers, GA 30012
Phone: (770) 388-0626
or (800) 321-7212
Fax: (770) 388-0936
Pump Accessories
FLOW CONTROL VALVE
This is the only accessory required to turn an airless sprayer
into an injection pump. It allows the operator control of
resin flow at the point of injection.
BRASS "F" VALVE ASSEMBLY
This low cost valve assembly was designed to “twin
stream” Prime-Flex
polyurethanes with water. The mix ratio is controlled
by the operator using the two on/off valves that come with
the assembly. This is especially useful for injecting Hydro-Gel
into leaking manholes.
STAINLESS STEEL "F" VALVE ASSEMBLY Similar to the Brass “F” Valve Assembly,
this unit is all stainless steel.
WALL STINGER NOZZLE
This attachment screws directly on to either of the “F”
Valve Assemblies. It allows injection of chemical grout directly
through a concrete structure without the need for an injection
port. This is ideal for grouting behind a manhole or a below-grade
wall. Not recommended for high-pressure crack injection.
PRESSURE GAUGE
0 to 3000 psi pressure gauge can be used on most pumps or
on the flow control valve to measure pressure at the point
of injection.
